Bronco 6G Front Bumper System

Front Winch Bumper for the Bronco by MetalCloak. Rock-Crawling heritage and desert race inspired design with utilitarian functionality. Clearance, Protection Lo-profile winch mount, practical utility with great looks.

Features Include:

• 3/16" Steel Base
• 2"OD X .125 Wall DOM Tube
• Lo-profile Winch Mount
• Full Length Skid Plate
• Provisions for Factory Sensors
• 2 Machined 1x2 Steel D-Ring Recovery Points
• Frame Mounted Strength
• Cut Out For Lights/With Fill Plates
• All Hardware Required
• Made in the USA

MetalCloak's Front bumper for the Bronco mixes the strength of our rock-crawling heritage with desert race inspired looks and all the [click for more...] features and function you want from a bumper. The strong 3/16" steel base attaches to the tube end caps and completely wraps around to the sides of the vehicle providing full protection. Choose between an aluminum or steel full length skid plate that runs from the bumper to your center section to ensure you slide up and over the hazards on the trail.

The lowest profile winch mount possible was made to keep "center of pull" low and allow unrestricted of airflow to the engine. Massive recovery points made of machined 1x2 machined steel are at the ready when the time comes. The D-Ring Recovery Points have a rounded edge design that allows for either the use of a standard metal D-Ring or Soft Shackle.

Every aspect of this bumper has been thought out; sensor holes to retain factory safety features, angled end caps for clearance, cut out for additional lighting (with fill plates) and some of the best approach angles you are going to find.

If you are Looking for a fantastic addition to upgrade your bumper for your Bronco; get the protection, clearance and additional practical features from a MetalCloak Front Bumper that is made right here in the USA.

Note: The MetalCloak Bronco Front Bumper does not fit the Bronco Raptor.

[click for less...]

CURRENTLY SHIPPING WITHIN 2-3 WEEKS